Introduction

How to remove the front bumper on your Holden VE Commodore! Whilst the concept appears difficult, the process is actually fairly simple. The bumper is held in place with a small number of bolts and screws.

Difficulty Rating

Moderate

Tools/Parts Required

  • Socket Set
  • Flathead Screwdriver
  • Trim Removal Tool

Step 1

Unscrew the two bolts in the centre of the bumper (Red), then remove the two scrivets (Green).

Step 2

Removal all screws running along the bottom of the bumper. These attach the bumper to the splash shield.

Step 3

Now we need to remove the bolts which attach the bumper to the fender. These are located as shown.

Step 4

To remove these bolts we recommend you remove the front wheels and remove most of the plastic wheel arch liner. It makes the job much easier.

It can however be done with the wheel still fitted. You’ll need to remove three scrivets holding the wheel arch lining in place, then you will be able to access the bolt.

Step 5

Remove both bolts on both sides of the vehicle.

As you can see here, the nut fits into a hexagon cutout. Take note of this when reinstalling the bumper as the nut must slide into the cutout!

Step 6

The bumper is now held in place by clips underneath each headlight. With the help of a friend, gently pull the bumper away from each headlight.

You may need to use a trim removal tool to push onto the clip and release it.

Step 7

If fog lights are fitted to the vehicle, these will now need to be unplugged before the bumper can be completely removed.

Your front bumper should now be free from the vehicle. To re-attach simply reverse the steps!

Did you find this guide helpful? Consider sharing it to help other car enthusiasts

Facebook
Twitter

This Post Has 8 Comments

  1. Richard

    Very helpful. Needed to replace the front bumper on my sons VE SSV and this is exactly what I needed to do the job. Thank you.

  2. Adrian Furniss

    Please load instructions on rear bumper removal on ve clubsport

    1. Staff @ AutoInstruct

      Hey Adrian, We don’t have access to a VE at the moment, so won’t be able to do this unfortunately.

  3. Adrian Furniss

    Ok thanks
    There seems to be a plethora of front bumper removal videos but not one of the rear

    1. Staff @ AutoInstruct

      We’ll see what we can do in the future!

  4. colin schofield

    how about removal of the rear bumper on a VE Wagon need to fit a tow bar also where does the module connect.
    need help guys please ASAP

    1. Staff @ AutoInstruct

      Hello, Unfortunately we don’t have a guide for a rear tow bar or trailer connection.

  5. MrSloth1496

    Would someone be able to tell me what the part is called that the has the hexagon screw thing as mine is broken and needs replacing

Leave a Reply to Staff @ AutoInstruct Cancel reply