Introduction

This guide will show you how to access Engineering Mode on your VE Commodore. This guide is suitable for all models, and no tools are required!

Difficulty Rating

Easy

Tools/Parts Required

None

Step 1

Insert your keys into the ignition, don’t turn them just yet!

Step 2

  • Press and hold the left scroll wheel on the steering wheel.
  • Whist holding the scroll wheel, turn the keys to the ON position (You can also start the car if you choose to do so)
  • Once the system check has completed, let go of the scroll wheel
  • You are now in Engineering Mode!

Step 3

Engineering Mode Page 1

There are many different line items to be found in Engineering Mode. You can scroll through these by using the left scroll wheel

Software Version
Version number instrument cluster

GM Part Number
Part No. of the instrument cluster

Battery Voltage
Shows the current voltage from the battery

Battery Charge
Shows the current charge of the battery.
Note: This will never show 100%, and could show a false figure. It may say 60% charge however the car won’t actually start.

Step 4

Engineering Mode Page 2

Remaining Fuel
Litre amount of fuel in the tank. This can be misleading as there is still reserve fuel after 0.00L is displayed

Instant Fuel Consumption
Instantaneous fuel usage

Coolant Temperature
Displayed in degrees celsius

Vehicle Speed
Digital speed readout

Step 5

Engineering Mode Page 3

Digital Tacho
Currently 0 as the engine is off

Tyre Pressure
Only displayed when the factory TPMS is installed

Engine Oil Life
This percentage is calculated based on your driving habits. See our guide here on resetting this value

Park Lamps
Indicates if the parking lamps are currently ON or OFF

Step 6

Engineering Mode Page 4

Switch Voltage
This is the voltage measured off the steering wheel controls (Used for fault checking)

Current Gear
This will say ‘Unknown’ in manual vehicles

Throttle Position
% of throttle input received from the accelerator pedal (This will never be 0% as the car uses a base figure to idle)

Transmission Sump Temperature
This seems to be disconnected from manual gearboxes as the temperature floats around ambient

Step 7

Engineering Mode Page

Full Test
This will activate a test mode within the cluster, where all LEDs will turn on, tachometers centred and the speaker will emit a constant beep. This is used to ensure everything is working correctly

Exit
To exit Engineering Mode, simply click the trip button

Did you find this guide helpful? Consider sharing it to help other car enthusiasts

Facebook
Twitter

This Post Has 23 Comments

  1. Myth

    I have a 2010 VE Calais, Can anyone tell me if it’s possible to turn off the Rest Mode Alert permanently, and if so…How ?

    1. Staff @ AutoInstruct

      Don’t believe this is possible.

Leave a Reply