Introduction

AutoInstruct presents a tutorial on how to remove the rear seat base on a VE Commodore.

Tools Required

  • None!

Intro

Removing the seat base is a very simple task. There are two clips holding the seat in place, one between the legs of each outer passenger.

Step 1

Grasp the front of the seat base and pull firmly upwards to release the clip. Once this is completed on both sides of the vehicle the seat will simply pull out away from the backrest.

18 comments on “Rear Seat Removal

  1. Aaron says:

    Hi there I’m trying to remove my parcel tray (without destroying it lol) do I need to remove the seats first?

    • Staff @ AutoInstruct says:

      Hi Terry, If there is no access hole under the back seat, you need to drop the fuel tank as the filter is located within it, attached to the pump.

  2. Josh says:

    Hi, do you have anything on removing the front driver side seat and how to disconnect all the sensors and stuff that go with it. My car is a VE Commodore Berlina 2007

    • Staff @ AutoInstruct says:

      Hi Josh, We don’t have front seat removal guides. However I can tell you that once the rear bolts are removed, the seat will hinge forward and release from the vehicle.

Leave a Reply

Your email address will not be published. Required fields are marked *