Introduction
This guide will show you how to enable ‘Pollution Mode’ on your Holden VE Commodore. Suits most Series 1 and Series 2 models.
When enabled, pollution mode automatically selects air re-circulation when the vehicle speed is less than 15 km/h. This is aimed at preventing exhaust fumes entering the cabin in stop/start traffic or whilst waiting at the traffic lights. Upon reaching a speed higher than 15 km/h, the air re-circulation is turned off. This happens continuously whilst pollution mode is enabled. It essentially allows outside air to only enter the cabin when the vehicle is moving at speed.
Difficulty Rating
Easy
Tools/Parts Required
Nil
Did you find this guide helpful? Consider sharing it to help other car enthusiasts
Facebook
Twitter
This Post Has 8 Comments
Hi, this does not seem to work. The vents just make mechanical moving noise regardless of how long it’s held for.
(2010 VE series 2 Wagon)
That’s odd, I’ve never seen this fail on a Series 2 VE. Check your owners manual, It should be in there as well.
This worked for me. Good to know 🙂
VE SII wagon
Hello AutoInstruct,
Do you happen to know the location of the cabin intake when recirculation is switched on in a VE? I understand the intake closes in the engine bay, but where or how does the air recirculate within the car itself?
Many thanks!
Paul.
Hi Paul, It’s behind the glovebox, up high from memory. It effectively pulls air from behind the dashboard.
Thank you, I was not aware of this on my V VE that I only just bought.
It didn’t come up with the on/off when I did this but it is no longer going automatically into recirc when I turn on the air-con so I guess it worked!